Your shopping cart is empty!
Your shopping cart is empty!
12-point sockets. Made by the method of cold stamping. Material - chrome-vanadium tool steel CrV..
0,00€
5-piece set of pullers for ball and tie rod ends in a case. The steering bipod puller set will simp..
65,73€
Ball joint installer and carrier kit. This tool removes and installs lower ball joints used for Mer..
42,05€
Quickly removes the ball joint from the drive shaft without damaging the joint. Reduces the risk of..
11,63€
Ball bearing puller 21". A special puller that allows ball bearings to be disassembled without the ..
11,25€
The SATRA ball bearing puller allows dismantling of parts without the use of tools such as a hammer...
8,87€
Ball bearing unibody puller 20-50mm / 22mm ASTA. ..
12,41€
Used to remove steering and suspension ball joints. Jaw opening: 20 mm. Maximum opening capacity: ..
7,66€
Used for dismounting ball joints and tie rods with pin diameter up to 30 mm. Made of 40HFA tool s..
31,08€
Used for dismounting ball joints and tie rods with pin diameter up to 20 mm. Made of 40HFA tool s..
15,19€
Used for dismounting ball joints and tie rods with pin diameter up to 19 mm. Made of 40HFA tool s..
43,09€
The Verke 5 ton hydraulic puller is the ideal tool for dismantling bearings, gears, hubs, bushings a..
49,88€
The SATRA S-CVBC joint guard clamp pliers can also be used for oil or fuel lines. The special desig..
9,53€
Used for tightening and fixing CV joint steel band clamps. Intended for all brands of cars. Equi..
7,95€
Intended for removal and installation of CV joint clamps. Intended for CV joint clamps, fuel line..
9,04€
Used for removal and installation CV boot clamps. Intended for the most modern vehicles. Equippe..
6,45€
Intended for removal and installation of CV joint clamps. Intended for CV joint clamps, fuel line..
13,73€
6-point operating profile. Made by the method of cold stamping. Material - chrome-vanadium tool ..
from 1,06€ to 5,77€
Designed for use with pneumatic percussion tools. Twelve-sided working profile. Standard connectio..
from 3,04€ to 3,28€
Designed for using with a pneumatic impact tool. 6-point operating profile. Square drive 1/2". ..
from 1,60€ to 5,47€
Designed for coil spring compressing during car repair works. Have doubled stamped hooks. One..
from 10,47€ to 18,25€
Tap wrench is made by cold stamping method. Has a swivel head and a spring-loaded retaining ball...
from 3,45€ to 27,85€
Intended for dismantling and installation upper nut of the shock absorber front strut VAG. Includ..
6,85€
